Module Construction Evaluation Check Sheet
Name Date
B. Module Standards
1. Module Table Ends Vertical Accepted____
Table _____ Left ______ Right _____ Table _____ Left _____ Right ______
Four quick acting clamps available: Yes _____ No _____
Note:
2. Module Legs with Screw-eyes of Proper Size - 5/16" or greater Accepted ____
(clockwise from left rear)
Table _____ Leg 1 _____ Leg 2 _____ Leg 3 _____ Leg 4 _____
Table _____ Leg 1 _____ Leg 2 _____ Leg 3 _____ Leg 4 _____
Note:
3. Screw-eyes with Proper (40 +- 1") Vertical Adjustment to Top of Rails Accepted____
(clockwise from left rear)
Table _____ Leg 1 _____ Leg 2 _____ Leg 3 _____ Leg 4 _____
Table _____ Leg 1 _____ Leg 2 _____ Leg 3 _____ Leg 4 _____
Note:
4. Main Track Ends on Proper Center lines Accepted____
Table _____ Red Line ____ Yellow Line _____
Table _____ Red Line ____ Yellow Line _____
Note:
5. Main Track Rail Ends Vertical to Table Ends Accepted____
Table _____ Red Track Left End ______ Red Track Right End ______
Yellow Track Left End ______ Yellow Track Right End ______
Table _____ Red Track Left End ______ Red Track Right End ______
Yellow Track Left End ______ Yellow Track Right End ______
Note:
6. Curves with Acceptable Radii (30" or greater) and Tracks Vertical to Table Ends Accepted____
Table ____
Red Track Curve Radius _____ Does Not Apply____
Yellow Track Curve radius _____ Does Not Apply____
Note:
7. Right hand track ends with joiners and all track ends undercut from ties for K 1" Accepted____
Note:
8. Proper Alignment Bore Hole Placement (see Construction Rules) Accepted____
Table _____
Left End ______ Right End ______
Table _____
Left End ______ Right End ______
Note:
9. Alignment Pins Available (2 per table) and of Correct Size Type (5/8" OD) Accepted____
Note:
10. Overall Evaluation Acceptance Yes _______ No _______ Date _________________
Evaluator’s signature _______________________________
Evaluee’s signature _________________________________